The application will calculate following:

+ Mixture Density

+ Erosional velocity

+ Minimum pipe cross sectional area

The input is available in SI and US Units of measurement.

If the Mixture density is defined the application will not calculate the Cross sectional area, to calculate the mixture density and the cross sectional area, extra input is needed, Operation Temperature, Pressure, Gas/Liquid ratio, gas compressibility factor, gas specific gravity and liquid specific gravity.

The erosional velocity calculator also has predefined set values of the equation empirical constant “C” for the following set of service conditions

Continuous non-corrosive service – (Factor available assumes clean fluid and carbon steel pipe material)

Intermittent non-corrosive service – (Factor available assumes clean fluid and carbon steel pipe material)

Continuous corrosive service – (Factor available assumes clean fluid and corrosion resistant pipe material)

Intermittent corrosive service – (Factor available assumes clean fluid and corrosion resistant pipe material)